by admin ~ October 25th, 2009. Filed under: Tutorials.
-
-
All pieces pulled through the correct slots.
-
-
Pulled through foam pieces.
-
-
Now sew around the remaining sides of the Pauldron neck parts.
-
-
Completed look almost.
-
-
After sewing complete, trim excess vinyl from around edges.
-
-
Sewing around edges of Pauldron to complete all seams.
-
-
Completed inserts and all seams sealed.
-
-
3/4" double fold automotive upholstry binding is used to seal all sides.
-
-
Beginning of sewing of binding.
-
-
Binding is wrapped around the entire perimeter of the Pauldron.
-
-
Binding around neck area is a separate piece from the outside edge binding. The neck binding overlaps the outside binding.
-
-
The neck templates are laid out and marked on the leather, notice all holes are pre-marked.
-
-
Elastic, 12.5 " pieces are cut, and leather pieces are sewed on.
-
-
Leather pieces are cutout, and holes punched.
-
-
Holes punched.
-
-
Leather neck pieces are laid out, and punched, and rivets inserted.
-
-
Shoulder parts are added, carefully to get the correct placement. Punched, and rivets added.
-
-
Holes punched ready to take rivet.
-
-
Neck pieces added, now ready for snap closure.
-
-
Snaps used to close neck.
-
-
Top snaps are added to the front side of the Pauldron, remember Pauldron hangs from the right shoulder.
-
-
Bottom snaps are added to the back side of the Pauldron, Pay attention to get these correct.
-
-
Pauldron is complete, check for correct adjustment.
-
-
Completed Extremely accurate Pauldron 4-5 hrs of work.
